Freedom Fighter Full length Magazine Tube install

[kimurabean]

I;ve found a great full length magazine tube for my benelli M4, but I was wondering if there is other things I need to purchase with it...like a spring? etc? or does it come with all the parts?

 

 

 

 

http://freedomfightertactical.com/products-page/922r-compliant-full-length-magazine-tubes/finished-titanium/

[Lexusf]

You can use your factory spring mine works fine. you dont need any other parts

[kimurabean]

nice to hear...thanks.

[seasam]

some people like to put a wolff spring / carriercomp in there - not sure how necessary that is, but I did it.

[ARMT Guy]

That comes with the correct length spring, so you're good to go with that kit, ( aside from needing a heat gun. )

 

I ordered the same thing for mine, but decided to replace the follower with one from FFT, too.

[kimurabean]

That comes with the correct length spring, so you're good to go with that kit, ( aside from needing a heat gun. )

 

I ordered the same thing for mine, but decided to replace the follower with one from FFT, too.

 

So I assume using a heat gun is to seal the tube into place or remove the old tube?

[truckcop]

Remove the old tube

[seasam]

these instructions are helpful. about to do mine soon:

http://www.carriercomp.com/FAQ.html

[Case]

The heat gun breaks the threadlocker where the original mag tube is screwed into the receiver.

 

There is a lot of variability in how long you have to heat it up to get it to break loose. The carriercomp instructions didn't work for me at all; I had to heat the receiver much hotter than they instructed. Some break loose without too much effort. Mine was a b*tch.