johnlewjohn Posted May 10, 2015 Share Posted May 10, 2015 I am trying to replace my follower in the M3 Super 90. This is the full length tube. It has the finger plate (tilt and remove) and then there is a retaining plate or clip, that I assume should come out? This is different than the SBE ones with the two holes and slot for use with retaining clip pliers. This is also a factory full length with no screw on retaining cap. Any suggestions from anyone who has tried this? Thanks John Quote Link to comment Share on other sites More sharing options...
truckcop Posted May 10, 2015 Share Posted May 10, 2015 You'll have to unscrew the magazine tube from the receiver. Quote Link to comment Share on other sites More sharing options...
Vertigofirearms Posted May 11, 2015 Share Posted May 11, 2015 (edited) Ha, good luck. You are going to pull your hair out if you do not possess the proper tools (go to a gunsmith). There is one possible alternative to remove it.... the chances of a safe removal is slim. Purchase one of these, you will need it. Edited May 11, 2015 by Vertigofirearms Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.