Ethos floor plate

[Caribou]

 Ethos 12gauge. 

When I feed a shell in to the open receiver and close it with the release button, then feed a shell in to the magazine tube, the floor plate stays in the "IN" position and I have to try to snag it with a fingernail to get it to drop back down so the second shot will feed. Happens every time, gun is 3 years old. Taken a part and cleaned but nothing helps. 

[Caribou]

I can’t edit my post but wondering if anyone has a fix for this. Thanks 

[remarkable]

Could certainly help you with this.  Your trigger gaurd is slightly out of tolerance which is causing the Carrier to bind ever so slightly.  A gently/very lightly sanding in the correc t location your ethoc will be good to go.  

Please let me know if I can help.

 

[Caribou]

23 hours ago, remarkable said:

Could certainly help you with this.  Your trigger gaurd is slightly out of tolerance which is causing the Carrier to bind ever so slightly.  A gently/very lightly sanding in the correc t location your ethoc will be good to go.  

Please let me know if I can help.

 

Thank you, could use some help. Is there a way to send you a direct message? It’s not allowing me to do it. 
 

[bambihunter]

@Caribou, 6 posts are required before one can send personal messages due to previous spamming issues on the forums. I'd be careful about just adding a couple more posts (make them relevant to this or other topics), but then you should be able to after that. It shows you have 4 posts currently.

[Stitch]

I’m having the same issue. Where do you sand ?  Thanks

[remarkable]

I will see if I can get photos in the near future when I work on my next Ethos.