Nikolai552 Posted August 30, 2008 Share Posted August 30, 2008 I have a +2 tube extension on my SN TAC as you all know, and was wondering, if i sight in my red dot with that on (the extension is kind of heavy) and then i take it off and go back to factory spring and spring retaining cap, will i lose my zero and have to resight it in? - If this doesn't make sense, let me know and i will try to re-word it. Quote Link to comment Share on other sites More sharing options...
Unobtanium Posted August 30, 2008 Share Posted August 30, 2008 I have a +2 tube extension on my SN TAC as you all know, and was wondering, if i sight in my red dot with that on (the extension is kind of heavy) and then i take it off and go back to factory spring and spring retaining cap, will i lose my zero and have to resight it in? - If this doesn't make sense, let me know and i will try to re-word it. If you are questioning component flex due to under 1# of weight altering your POI on a shotgun, I would not worry about it. Even with a Tru-Ball slug you are looking at around a 4MOA weapon. Try it and see. Quote Link to comment Share on other sites More sharing options...
Nikolai552 Posted August 30, 2008 Author Share Posted August 30, 2008 So you think i could sight it in with the extension on and then take it off for deer hunting and still same POI? Quote Link to comment Share on other sites More sharing options...
cody6.0 Posted August 30, 2008 Share Posted August 30, 2008 I take you are using a extension that has a barrel clamp on it? If yes it shouldn't be pulling things that hard to force a change in zero installed vs removed. Quote Link to comment Share on other sites More sharing options...
Nikolai552 Posted August 30, 2008 Author Share Posted August 30, 2008 No clamp for extension, is that bad? Didn't even think of getting one. I used it like that the first time out and no problems, just had my iron sights then. Heck, i even hit a tomater' at 50 yards with my first shot. - So there will or will not be a change in POI after i switch the extension out for stock setup? Quote Link to comment Share on other sites More sharing options...
cody6.0 Posted August 31, 2008 Share Posted August 31, 2008 Since we are talking about a 12ga here and not a .22 removing your tube should have no effect even a full disassembley shouldn't disturb anything. Quote Link to comment Share on other sites More sharing options...
Nikolai552 Posted August 31, 2008 Author Share Posted August 31, 2008 Alrighty then, that answers my question . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.