Leaderboard

I'm starting to think the polymer trigger frames are to blame for a lot of the FFT fitting issues. I have ClackClackBAM's trigger pack here. The hammer hangs up on the disconnector. So I swapped his FFT kit for a brand new set I got in today. Same exact issue. I dropped both kits in to an A&S Engineering frame and it worked just fine. I tried the FFT in a spare polymer frame I had in the safe. More disconnector hang ups and tight fit around the hammer.

Sorry guys, been busy dealing with Obama's kids. I definitely treated myself when I bought that Wilton. I should have went for the 6" though, but I was already at the 500 range. Really like using it over my old Polack vice with busted jaws. Brownells sells large rubberized mats that are heavy duty. They are a little pricey though. Especially when you have to buy 8 of them like I did.

Well the problem wasn't with the FFT parts. My OEM housing has an issue and I'm about to contact Benelli to address it.

also the bolt release is made by Arredondo and its $22 on brownells

Let's hope that wasn't his attitude towards his products...

I have six Milwaukee work benches in my shop currently. Each one has a thick rubberized mat on them. I bolted my new Wilton vise to the wood top to one of them. The main work area gives me a work bench that is 10' x 4' wide. All soft close drawers on these benches. An ultrasonic cleaner is over on one of the back wall benches full of Hoppes #9. I'll be bringing in a blast cabinet in soon. My lathe is out of view in these shots.