Leaderboard

I recently bought bought an Ethos Sport and am working on getting it adjusted to me. One thing I notice is that if I grip the gun in a natural way, my finger barely reaches the trigger. I also own a Super Nova and I don't have that problem with that gun. The grip to trigger distance is shorter. This is not an LOP thing. Is there a product designed to adjust this? I could pile up some moleskin on the grip but that won't look very good.

That’s an Elite Iron bipod. Built like a tank and as a unique pivot mount. https://www.eliteiron.com/product/revolution-bipod/

No, that’s not normal for removal. Can you post pictures of the receiver extensions? Check beneath the cheek rest for any screws. Some of the California models have these present that prevent the stock adjustment button from functioning. Have you reassembled the stock? Now that it is reassembled, will it install onto the 3 position extension?

I believe your issue is you don’t have much leverage on the tube itself since I assume the 3 position extension isn’t attached to the firearm or anything. Try pressing the unlock button and holding it in while you attempt to rotate the stock 90 degrees to the right. Once it rotates, continue pressing the unlock button and slide the stock up and down the receiver extension. You’ll note that the stock will move fully forward to the closed position. The stock will still be canted 45 degrees to the right. Now try to rotate the stock 45 degrees to the left so the stock would be correctly orientated. Now let off of the unlock button. Now press the button again, rotate 45 to the right and extend the stock fully. Rotate 45 to the left. Now there is a center middle position on the 3 point stock. You’ll also note there is a disassembly notch between the middle and the farthest extended position. Once aligned with the disassembly notch, you’ll rotate the stock 90 degrees to the left so that the stock is canted 45 degrees to the left. Then the stock will pull free off of the extension. Oil should be applied to the receiver extension so that it has a nice uniform finish this should help with the sticking issues in the future.

Thanks it was featured in the magazine Tread.

Anyone notice that Benelliparts has a new charging handle for the Benelli M4? Other than being steel, it appears to be very similar to the carriercomp charging handle. https://www.benelliparts.net/store/p44/PRE_ORDER_1%2F2”_Steel_charging_handles_for_the_Benelli_M4_shotgun_ETA_3-4_weeks.html

Rifled slugs are to be used in smooth bore shotguns, you could add a rifled choke tube but that is not necessary. Modified (.20”), is the most constrictive choke you should use with slugs, and never use a FULL choke. You can go larger diameter ie; Light Modified (.15”), Improved Cylinder (.10”), Skeet (.005”) or Cylinder Bore (.000”). Sabot rounds are for FULLY rifles barrels, which the Benelli M4 is not. Also check you choke tube often and make sure it is tight! Remove and clean often and make sure you use a light grease or an anti seize lubricant on the threads so the choke tube won’t seize up. Some shooters have a problem with the choke tube loosening up quite often and the anti seize or a small amount of Teflon tape will help with that. As far as accuracy goes, each barrel/gun combination likes what it likes. Try different brands of ammo and see what your weapon happy… http://www.briley.com/boresizesandconstrictions.aspx