Leaderboard

I didn't care for the stock M4 handguard but after getting it stippled I might remove the Briley from my other M4. Work was done by a member here "Nikotheasian". This guy is legit!

Wanted to share a 2 parts I have been working on for the M4. I designed these and printed them in Nylon Carbon Fiber PA12-CF. I am still tweaking the design and looking for some feedback. They install the same as the factory handguards but do have 2 m3 socket cap screws that secure the 2 halves together using heat inserts. The flashlight mount is for a Fenix PD35 Tac but can be sized for any light.

Hard to believe it’s been 8 months since I dove into this. Learned a lot along the way, and I truly believe the steps I’ve taken on this tube makes it the best on the market. Finally, the tubes are on the truck back to me, completed and ready to go. Hopefully next week I’ll have them in hand and start shipping out to back orders before listing them as “in stock” I’ll be testing each tube to confirm fitment on my M4s before packing them to ship out so I have a long few weeks ahead of me