M4 barrel shortening and stock shortening

[snipermedic]

Hi,

I am a gunsmith, soon to be Class 2 manufacturer, I have cut down several M4 barrels to the factory 14" Entry Model. I face and chamfer the OD, shim the front sight and mag tube and lightly spot TIG weld them in proper location. This is stronger than silver soldering and if done properly, uses minimal heat. I then open choke to IC for proper patterning. I charge $250 plus shipping.

 

I can also shorten the factory stock length. After I cut to your desired length, I make a custom, removable aluminum adapter for mounting a Sims Recoil Pad, properly fitted to your gun. Cost is $150 plus shipping.

 

Understand you must have your approved ATF Form 1 back before you can mount this on the reriever or even have the barrel and receiver in the same location. I will soon be able to do entire SBS conversion, including ATF paperwork and engraving for direct return to you (if in Maine) or your local Class 3 dealer in your state.

[Scout_21]

Awesome! It would be great to have an engraving source that could use the same font as benelli does.

[calviroman]

Sounds great -- can you please post or link to some detailed pics of your work?

[Unobtanium]

I'm interested, as well. I would like to see some credentials/work/etc. as well. If your work is as solid as it sounds, and your turn-around time is within a couple of weeks, you're going to be a very popular guy (or girl, let's not be sexist, maybe some super hot girl is doing work on barrels and stocks, some of my past gunsmiths have been bombshell hot blondes, sooo...pictures of you, too, if this is the case!).