Sure Cycle Bolt Handles

[Xchief30]

Has anyone used  or seen this ?

https://www.surecycle.com/products/benelli-frag-bolt-handle-black

Just looking for your opinions...

 

Thanks

 

[NineInchNails]

If you check out Freedom Fighter Tactical's Charging Handle, you'll see a big difference at the tip of the rod. If I'm not mistaken, the charging handle you linked to would probably spin 360°.

The charging handle on the bottom is the OEM Benelli M4 Charging Handle and the Freedom Fighter Charging Handle is on top.

[Chile1]

On 12/21/2018 at 9:26 AM, NineInchNails said:

The charging handle on the bottom is the OEM Benelli M4 Charging Handle and the Freedom Fighter Charging Handle is on top.

 

?

[Xchief30]

I ended up ordering this one

 

https://www.shopbenelli.com/bolt-handles/60220

 

Made by Benelli so it should not rotate either....

 

Thanks

[Chile1]

I purchased the Tango Arms charging handle:

 

 

[NineInchNails]

.

Edited December 27, 2018 by NineInchNails

[NineInchNails]

On 12/23/2018 at 2:15 PM, Xchief30 said:

I ended up ordering this one

 

https://www.shopbenelli.com/bolt-handles/60220

 

Made by Benelli so it should not rotate either....

 

Thanks

That bold also appears to have been machined round without any facets. It will spin 360°

[NineInchNails]

Look at the tip of that charging handle. Notice how the groove is ground all the way around. This charging handle will spin.

[NineInchNails]

Look at the tip of these charging handles. Notice how the groove is NOT ground all the way around. This charging handle will NOT spin. These ground flats are what engages a detent and keeps it from spinning. When the groove is ground all the way around, the detent only captures the charging handle, but there is nothing to stop it from spinning 360°.

 

[Evolution]

yep...if that benelli handle is a true representative example of the part, it's going to spin. Personally.....i've never found the need to replace the oem bolt carrier handle, or the release button with larger style aftermarket types. 

[Xchief30]

You guys were correct. Benelli part does not have the indents. I didn't even try it in the gun. It's not even bigger than the handle that comes with the gun. Hopefully they'll take it back.