JTs M4 Posted March 27, 2022 Share Posted March 27, 2022 (edited) I saw this new Benelli M4 entry and noticed the front sight was way off to the right.. I've never seen a new M4 with the sight this far off centered.. poor QC or problem ? Edited March 27, 2022 by JTs M4 Quote Link to comment Share on other sites More sharing options...
Fullassault Posted March 27, 2022 Share Posted March 27, 2022 Is it actually canted or just not zeroed? Min was off center (not that bad) when I got it. After I zeroed it , it was dead center. Quote Link to comment Share on other sites More sharing options...
JTs M4 Posted March 27, 2022 Author Share Posted March 27, 2022 15 minutes ago, Fullassault said: Is it actually canted or just not zeroed? Min was off center (not that bad) when I got it. After I zeroed it , it was dead center. I'm not sure, it isn't mine I just noticed it in the photos when I was looking it it and made me wonder why it would be so far off centered.. Quote Link to comment Share on other sites More sharing options...
Steve Rose Posted March 28, 2022 Share Posted March 28, 2022 13 hours ago, Fullassault said: Is it actually canted or just not zeroed? Min was off center (not that bad) when I got it. After I zeroed it , it was dead center. My first thought too....Loose and sliding side to side while in the box? IF NIB I'd say just not zeroed, but if the gun has been used and zeroed maybe there are other circumstances? Quote Link to comment Share on other sites More sharing options...
StreetSweeper56 Posted March 28, 2022 Share Posted March 28, 2022 The nut holding the front sight strips easily. I replaced the sight on 1 of my M4's that was stripped and loose from the factory. A replacement nut was $7 + not including shipping. You will also need a 5.5 mm mini wrench, this is the one I used: https://www.amazon.com/Acu-Min-51-1836-Wrench-millimeter-Overall/dp/B004W8D7LU/ref=mp_s_a_1_29?crid=9NTJFCA6XXXA&keywords=accu-min+5.5+mm+wrench&pscroll=1&qid=1648482518&sprefix=accu-min+5.5+mm+wrench%2Caps%2C342&sr=8-29&wIndexMainSlot=25 2 Quote Link to comment Share on other sites More sharing options...
D'zaster Posted March 28, 2022 Share Posted March 28, 2022 My 1014 new out of the box was the same. I centered and tightened w my (at the time) newly acquired 5.5mm wrench being careful not to over tighten and have been good to go since. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.