Leaderboard

Sold..

Ok, I’m officially an M4 (M1014) owner. However, this isn’t my first Benelli. Here’s my M4 with my competition M2. Now I just need to get the 3 position buffer tube and 7 round mag.

Expect 1200-1600 depending on accessories. Example, if you have a titanium magazine tube, that can't be plated, so the cost is lower. I built a forum member a high end AR15 that was completely NP3 plated. He took it to a 3 Gun competition and let some of the guys try it out. They stated it shot better than their race guns and it wasn't set up to be a race gun. It had a B.E. Meyers 249 flash suppressor instead of a comp. You could clean it with a paper towel except the bore.

https://www.dvor.com/vism-double-carbine-gun-case.html?promotion=dvor-s-most-wanted-gear-43-2021-10-07 I just ordered one of these. I've had one for a number of years and could use another. This is the best deal I've seen on Gun Cases.

I bought the first tactical for my M4. Great soft case for the M4, highly recommend. https://www.firsttactical.com/collections/bags-gun-bags/products/rifle-sleeve-42-inch

922r us Titanium tube, us follower, trigger & hammer. that said I asked the ATF a few years back about 922r and the one who replied back said 922r only applies to the manufacturer. Some people don’t care about it, some follow it religiously. Honestly it’s not something I stress over too much. If the US parts ever give me trouble, I’ll switch to oem parts and never think twice about it.

The flag and the M1014 roll mark for me!

I picked up one of these recently... albeit it's a double rifle case, it's got a ton of storage and can carry two long guns if needed. Urban Warfare 42" - Double Rifle Case – Savior Equipment

Nashville Typewriter