Leaderboard

I would be stunned if Taran makes a carrier for the m3. Again, little to no interest. This is coming from experience in the industry regarding “scaling.”

Moving the M4 front sight and magazine tube ring back for the shorter barrel configuration presents challenges, not only in the remove/reattach processes, but also due to the smaller barrel OD in the mid section of the 18” barrel which affects sight regulation and mag tube alignment if not properly compensated for before reattachment, not too mention keeping everything properly aligned via a fixture while reattaching the parts. That smaller barrel OD at the new muzzle may also limit choke tube threading possibilities. They may be a shop out there doing the conversion and the folks here on the forum would like to know if there is. We get asked about converting the M4 barrel to Entry length and always decline based on the above reasons. The factory Entry barrel is relatively expensive and often hard to source but in the case of the M4 it is the better route.