Rock7

In, In, In!!!1! Me, Me, Me!!1!!!

If you are changing JUST the hammer... It's super easy. Follow the directions that come with it and it will literally take less than 2 minutes. Seriously. Remove snap ring, push pin out far enough to remove hammer, replace hammer, push pin back in, install snap ring. The pin on mine was easily pushed out by hand with the help of a small screw driver. No hammering or punches required.

Ordered 2 January... Received today... [ATTACH=CONFIG]2175[/ATTACH] [ATTACH=CONFIG]2176[/ATTACH]

Mine is about 6 months old and it works fine.

Agreed. FLT.

Same here. Only 4.

I went with the 1/2" Ti from FFT. Perfect.

In!!! In!!! In!!!

Any update on this? Has the "movement" issue been addressed?