Facundo

From the research I've made, I think both the GG&G and the FTT are the best out there in design and performance. I don't think drilling something so small and delicate like the tiny little issued bold release should be done by anyone. I'll go with the GG&G. GG&G FTT

I'm interested! usually, Ti runs pretty smoothly on everything and its lightweight also.

Nice handguard. Do you know if there's already available for purchase somewhere? thx

I love my Supernova Tactical. Smooth operation, rugger as F!, reliable and dependable. The only thing as a con, is the weight but its built to last forever SERIOUSLY!

Hi folks, I've found these 2 models (below) that I believe might be the best charging handles for an M4 but still not sure about the bolt release. Any suggestions? Freedom Fighter Ti Charging Handle RX Arms Ti Charging Handle

Don’t need it. It actually locks in place super good.

No, I use the GG&G sling/rail combo mount with the Blue Force Gear ULoop in the front.

I think so, but placing the QD there would flip your stock sideways in VERY uncomfortable position tho. I followed what most assault rifles uses for positioning the QD

Yeah, sorry. I meant 5mm

I definitely recommend the use of a 3/16” (4mm) punch. It fits super snug, won’t chip the thread and works best. ATENTION!: Before trying to remove the stock, open it up full length or the thread will work against the stock.

Thank you! It’s easy, just gotta follow the Noveske QD flush directions and that’s it. The only thing that I’ve changed is instead of the Blue treadlocker I used the RED since is permanent.

It was a little annoying to find the head of the screw in the begging but I made it finally!

It was a little annoying to find the head of the screw in the begging but I made it finally!

Works awesome!