Leaderboard

I've had to fit many of those FFT trigger kits in recent years for hanging on the disconnector. I found the best option was to use a small file and to remove material from the hammer sear until the trigger disconnects properly. I like to do the work when the hammer is installed so I can quickly check my work. If you haven't done so already, set the spring retainer in the end of the magazine cap so it sticks out past the end of the magazine tube. As you install the magazine cap, you'll feel it press the retainer into the depth it needs. Setting the retainer in too deep can limit the room you have for shells. There are a lot of 2 3/4 shells that don't conform to the size standards. Stacking up 7 of them ends being slightly longer and prevents the 7th round from fitting.

FIXED!! https://rumble.com/v1nv98c-benelli-m4-freedom-trigger-post-filing.html Thank you everyone especially StrangerDanger, Don Randall and Streetsweeper for the hints and dialog. I really appreciate it!

There was a thread on this last year, Fetter will fit 7 but they're from Russia and I have not seen any for sale in quite a while. Fortunately, for me, I bought a boatload at the time. Even with 6 in the tube, 1 ghost load, 1 chambered and 5-7 on a side saddle that's a pretty hefty load out on board. I suggest a "match saver" as well. https://forums.benelliusa.com/topic/24945-fetter-00-buck/#comment-164436

OHHH. and I forgot to mention the most important disappointment in installing the 7 shot magazine tube. It only holds 6 shots. After all the hassle, you come to find out that the 7th shell wont fit. You are about 1/4" short. After much research I found a video where the manufacturer suggests that you shop around for an ammo brand that has slighter shorter shells so you can fit the 7th shell. So far I haven't found one.

EuroOptic.com

I don't see anything from your pictures that look abnormal. The component wear interfaces indicate a relative low firing rate. In regard to the FFT trigger assembly replacement for 922r compliance, I must complement you on the endeavor. The most complex part of any Benelli shotgun is the trigger assembly. I watched a FFT 922r trigger upgrade below. If you still are having the same issue after your next range event, I would reinstall the Benelli M4 OEM trigger components and retry. If still having issue, it is time to see the gunsmith.

Interesting, I shot 7 boxes with zero failures. I didn't notice any burred edges but I'm not the brightest crayon in the box so I may have missed it. I'll try some in a Vepr 12 I have but its never failed either. Maybe that's what the reviewer meant by "inconsistent". I'm going to start a database of actual calipered shell lengths of different brands. I REALLY want 7 shells in the tube!