Jump to content
Search In
  • More options...
Find results that contain...
Find results in...
Benelli Forums
D'zaster

M4 limited edition fixed skeleton stock question

Recommended Posts

Hey Guys,

I am new to this forum. Recently purchased a limited edition m4 with fixed skeleton stock. I am considering switching to something like the mesa urbino pistol grip stock for shorter LOP or going with the Benelli non-pistol grip stock.  What is the procedure for removing the lower part of the stock from the fixed recoil tube? Is this the same design/assy as the collapsable stock? When I press the button it wiggles but does not come off.

The M4 is replacing a Benelli Nova, hence my silly noob questions. Thank you in advance.

 

20200308_164534_resized.jpg

Share this post


Link to post
Share on other sites

If I'm understanding your question correctly, while holding the button in, turn the stock to the right, push up (towards the receiver), turn it back to the left, and then pull it off

Share this post


Link to post
Share on other sites

To remove the tail piece of the stock, press and hold the button on the stock in, rotate the tail piece of the stock about 45 degrees to right. Push the stock forward until it stops. Now while still holding the button in, rotate the stock 90 degrees to the left. Then pull the stock off the end of the receiver extension.

 

For the pistol grip portion, remove the trigger pack. Now unscrew the pistol grip from the receiver extension. It can be tight at first, and you should have about four full rotations before it will slide off the end of the receiver extension.

Share this post


Link to post
Share on other sites

Thanks for your replies! I am able to press the button (maybe not all the way?) but unable to rotate the stock to the right (or left).

Share this post


Link to post
Share on other sites
Posted (edited)
2 hours ago, D'zaster said:

Thanks for your replies! I am able to press the button (maybe not all the way?) but unable to rotate the stock to the right (or left).

Did you purchase your M4 in CA by chance?

 

Edited by RPC

Share this post


Link to post
Share on other sites

Check out the thread I linked to, there’s a screw under the cheek weld that has to be removed to activate the repositioning button, but by doing so you take it out of compliance with state law. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...