Leaderboard

I'm readin' them both at the same time as well!

I modified the pointed end to save weight, I was on a major weight saving mission, pointed end was a waste of weight.

Thanks for fast shipping, RX Arms. I just received my raw Ti handle. Fits perfectly!

Just got my black handle, looks much better!

PROBLEM SOLVED!!! ? Schutzhund, Thanks for the reply! You would know better than I would. I was quickly perusing the M3 manual and probably missed it. As far as I know, it is the same stock system, but I cannot remove mine like they show with the M3 (from the top as that extra "U"-shaped cutout is not on my grip). I think part of my problem is the factory had the retaining nut torqued down so much, it was going to be impossible to move it with something like the bolt. I went ahead and purchased the "Vmotor Chrome Vanadium Adjustable C Spanner Hook Wrench Tool - 3/4-2"(19-51mm)" from Amazon (link in previous post). The holes are 4mm in diameter, so the other wrenches on that page would be too big (correct size highlighted in screenshot with pricing). It's only $11. I'm guessing they use something similar to this in the factory. It loosened the nut with virtually no effort. The surface is wide enough, it doesn't mar the polymer top of the grip (although I'm sure over time I will start to see a little shine from it, but that is no big deal). It also allowed me to easily torque the grip back on so it won't loosen while shooting. I'll just keep this in my gun case with the gun. Hopefully this helps if anyone else runs into this. I still think Benelli needs to do a better job with providing information about this, especially on the pump SuperNova that doesn't have any sort of charging handle. Jeff