Gmcrigger2007 Posted January 23 Share Posted January 23 I ‘m running out of choke tube lube , is automotive never seize good to use on shotgun chokes ? Quote Link to comment Share on other sites More sharing options...
Sukhoi_fan Posted January 23 Share Posted January 23 I never buy choke tube lube, there's always an auto parts store nearby carrying Permatex Anti-Seize lube. In a pinch I'm thinking a very thin coat of RectorSeal #5 which can be found in plumbing supplies would suffice just fine. Quote Link to comment Share on other sites More sharing options...
Evolution Posted January 23 Share Posted January 23 Iv'e never worried too much about it....I just grab what ever is close at hand at the bench, be it some rifle grease, bearing grease or that silver NAPA auto parts anti seize it all works fine for the job.😊 Quote Link to comment Share on other sites More sharing options...
M2_shootr Posted January 23 Share Posted January 23 I use nickel anti seize compound…..have been using the same container for many years. A little goes a very long way Quote Link to comment Share on other sites More sharing options...
Gmcrigger2007 Posted January 24 Author Share Posted January 24 Thanks for all the replies. I ended up getting a tube of this stuff. 1 Quote Link to comment Share on other sites More sharing options...
FDHog Posted January 27 Share Posted January 27 I just use what I use on my pistols and rifles. TW25B. Little goes a long way. Quote Link to comment Share on other sites More sharing options...
bambihunter Posted February 12 Share Posted February 12 On my safe queens, I put a little gun oil behind the choke just as added anti-rust protection. Guns that get shot, I have never before used choke lube in my 45+ years of shooting. If I were to, I'd use a dry lube like I use for the action and magazine. Quote Link to comment Share on other sites More sharing options...
Sukhoi_fan Posted February 13 Share Posted February 13 JMO, but I would advise against using any light oil on the choke threads. A grease of some type will act as a gas check to prevent gas fouling of the threads whereas a light oil will contribute to the fouling over time (for those of us who don't remove the choke and clean it after each use). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.