Leaderboard

Got another one of these builds finally coming back from Wright Armory. Some bad, they seriously increased their pricing without any forewarning. This current M4 racked up 2200 dollars in costs with them for the plating. It used to be around 1150. They really stick it to you on the chemical stripping fees. I’m going to speak to the owner about the drastic increase to see what the deal is. It’s hard to give customers quotes when the pricing varies so much. This H2O will have a Trijicon SRO in place along with a set of actual Trijicon iron sights done up by ToolTech. The sight housing was done in NP3 already. Aftermarket will be a full build with a Carriercomp magazine tube, FFT fire control, elevator, spring kit, DMW oversized safety, TTI stainless bolt release, A&S Engineering frame, GG&G oversized bolt release, IWC light and sling mounts, Surefire M600DF weapon light, Scalarworks Sync top rail, stippled FFT forearm, Limbsaver 10403, BlueForceGear sling.

Good advice. I have the parts for everything I’ve taken off so far in separate zip lock baggies. I like it without the rear sight much better.

Regardless of whether benelli parts is legit or not, the owner crossed the line with his messages. Treating a customer like that obscene. Far too many other people to order parts from.

The screw heads are located on the inside of the receiver. Remove the trigger assembly and you'll see them. Be aware that when I removed the rear sight on my first M4 back in 2016 the screws appeared to be somewhat swaged. If that's still the case you'll likely need new screws if you want to reinstall it at a later date.

Thanks aznwhip, I'm the guy that bought your handguard and carbon fibertube.