Leaderboard

This is a ways off for me mostly due to my small business capacity at this time, but I’m going to be releasing a Benelli M4 QD Sling Mount for the rear collapsible stock in the future. Specifically made for the M4… once I have got the recoil tube for sale, I’ll be moving onto some other M4 products like this.

I can't wait to snag one of these tubes. I find for me with the stock fully extended, it's just a bit too long of a lop. It's definitely doable but I much prefer the middle position when shooting. So, because of that I had to buy the 10mm riser from Reptilia and that has helped tremendously when firing on the middle position but the sweet spot for me would be a notch on the tube that is in between the middle and fully extended positions on the oem tube. Looking forward to this...

Proving, once again, you get what you pay for but at least you learned a lot!

PVD aluminum titanium nitride came back, looks pretty killer… It is the only finish that exists out there that checks off all my high quality control boxes; primarily retaining the heat treat on the notches, extremely high corrosion protection, no tolerance interference, high wear resistance. Shout-out to the guy that put me on this path further back in the thread here. I have been told by the finisher that salt corrosion is essentially non existent with this finish… but no formal military testing has been done since it is used primarily for hard use tooling. experienced some minor delays at the machine shop, but this week is full production. Coming soon… (sample pic below that I abused a bit to test the finish… and my canine Apollo)

Id recommend a 1301 beretta as the floor, and a benelli m1,2 or 4 if you want to spend more. These clones are cheap because they're cheap.

there is one seller on Gunbroker right now that has (3) NIB 11715's @ buy it now for $2279.00 .. quite reasonable compared to what they have been selling for recently...

You can also remove the iron sights pretty easily. I find they clutter the optic and add extra unneeded weight. Decide which stock position you want to use primarily. I find the RMR to sit too low for the middle position of the collapsible stock. Fully extended it works fine. You can buy a spacer that fits between the RMR and the Scalarworks mount to raise the optic from Reptilia. They have 2.5mm and 10mm options depending on your preference. You'll have to modify the screw that come with the spacers to fit the Scalarworks, basically you're just shortening them to the needed length. This one is set up with the 10mm spacer.

ESD. I hard mount the sling at the back though vs using QD.