M2_shootr

Yep........works for me.

Meh,.......the replacements are junk anyway.

I did this about five years ago. Wanted a choke tool to more easily remove and install chokes. While there are some nice ones available, $20-30 is nuts for a uni-task tool -Take your Benelli factory choke tool and drive the cross pin out. -Drill the hole put to 7/32” -Chamfer the edges to remove any burrs -Use a #1 Phillips screw driver or a USGI steel cleaning rod section as a new handle

Hey there is hope..... I saw two 870 Surefire fore ends pop up for sale this week

This middle finger abuse was quite common with the Vinci. I thought the SBE redesign fixed that. Luckily......I’ve never had the issue.

Moved.........

I wonder if the new tube could be used with the old M4 straight stock body?

Why does that suck? It’s a shotgun, chokes loosen, unless you tighten them properly.

****......I use nickel anti seize on my choke tubes. Get one stuck and ou are in for a trip to a good gunsmith or machinist. Tighten it down with the supplied tool, check it every 100 shells or so

I was going down ^^^ that road,......then I discovered the Ava mount here. Game changa.......

I think it is covering the hardware for the light mount that is attached to the handguard

If this listing would have been posted a week earlier, I would have jumped all over it

The way I look at it is this. If Benelli can’t or won’t import the part, dealers and distributors can’t get the part imported, I sure as **** wouldn’t stuff one in a suitcase. There may be a bit of a gray area with a firearm part as opposed to an entire firearm. However, I default to the above. Take importation of parts from Canada as an example. There is a restriction upon what can be imported and the value is limited to $100 for one part and a limit of a total value of $500 for a single transaction. Last I knew bringing any part into the US from Europe required an APPROVED form 6 importation permit to be presented to customs upon arrival.

Congrats.......love mine!

I dunno, I may be wrong. US Department of State controls import and export of defense products. They also are the agency that controls/wrote ITAR. 1st page kinda explains it.......i think https://www.pmddtc.state.gov/regulations_laws/itar.html

The NRA isn’t going to be able to change ITAR regulations

ITAR regulations control both the export and import of weapons and related bits

Nordic Components mag extension GG&G clamp Mesa Tactical Urbino stock with the Limbsaver pad SureShell carrier

I’ll put up a pic of mine later today. However, did you realize this is an almost eight year old thread?

Smoking deal.......

I just soiled myself.........

Much appreciated Sir

I hear what you’re sayin.......

Yes Sir....

I hear what you’re saying......I have both optics. I don’t have both mounts, maybe I’ll try both & find out for myself 1st hand. Less view obstruction with the RMR I would prefer less of the sights in the optic anyway Auto adjust isn’t bad at all Changing a battery once a year is not a big deal Re-zero for the optic isn’t an issue either The only benefit I see to the AimPoint is it’s sealed from the elements. Where I’m at, if I were using something other than a pistol at the house, it would be an AR. And I sure as heck wouldn’t be chasing a bad guy outside. That is simply stupid and will get you a 8x10 jail cell